CM Archive

  • This application is for updating extension/directory numbers in CUCM 8.x/9.x. Currently there is no way of doing this using “Bulk Tool”. If you need to move a set of extension/directory […]

    Update Extension/Directory numbers in CUCM

    This application is for updating extension/directory numbers in CUCM 8.x/9.x. Currently there is no way of doing this using “Bulk Tool”. If you need to move a set of extension/directory […]

    Continue Reading...

  • This application is for producing reports that can either be used as an Inventory Tool by the Engineering finishing a CUCM install or by the CUCM Administrator running periodical Audit […]

    CUCM Phone Inventory Tool

    This application is for producing reports that can either be used as an Inventory Tool by the Engineering finishing a CUCM install or by the CUCM Administrator running periodical Audit […]

    Continue Reading...

  • Pause in Speed DialCUCM 9 New Features Users can configure speed dials with FAC, CMC and post connect DTMF Comma accepted in speed dial as delimiter and pause Feature allows […]

    CUCM New Features

    Pause in Speed DialCUCM 9 New Features Users can configure speed dials with FAC, CMC and post connect DTMF Comma accepted in speed dial as delimiter and pause Feature allows […]

    Continue Reading...

  • This setup was only used for outbound international calls only. All other calls used a diffrent SIP provider not shown here Was tested with CUCM 9.1 and IOS ver 15.2(4)M3 […]

    Skype connect with Cisco Cube

    This setup was only used for outbound international calls only. All other calls used a diffrent SIP provider not shown here Was tested with CUCM 9.1 and IOS ver 15.2(4)M3 […]

    Continue Reading...

  • Phone Firmware upgrade The below process to upgrade phone firmware has not failed me … yet, event after factory reset 1. Set up an SVI on the switch 2. Give […]

    Phone Firmware upgrade

    Phone Firmware upgrade The below process to upgrade phone firmware has not failed me … yet, event after factory reset 1. Set up an SVI on the switch 2. Give […]

    Continue Reading...